-
Material: V2A stainless steel (AISI 304)
-
Surface: Polished
-
Total length: 50mm
(total projection of the component)
-
Functional clamping length: 37.5mm
(distance from the tube edge to the inner stop surface)
-
Version: Depending on selection for Ø42.4mm round tube or for square tube
(Due to the design, the glass holder can be screwed onto round tubes or square tubes)
-
Bolt diameter: Ø8mm
-
Functional clamping length: 37.5mm
(tube contact surface to the center of the clamping piece)
-
Distance1: 17.5mm
(This is the distance from the tube support to the start of the glass holder)
-
Distance2: 15mm
(denote the length of the permanently integrated block inside the glass holder)
-
Glass holder depth: 26mm
(How far the holder extends outwards from the tube surface)
-
Glass holder height: 40mm
(total height of the holder from top to bottom)
-
Glass depth: max. 35mm
(How far the glass on the holder is covered in depth)
-
Clamping range (glass): 6mm, 6.76mm, 8mm, 8.76mm, 10mm, 10.76mm
(For glass thicknesses 6-10.76mm)
-
Clamping range (sheet metal): 1.5mm, 2mm, 3mm
(For sheet thicknesses 1.5/2/3mm)
-
Inner bore: Ø8.5mm
(inner bore for connecting element)
-
Screw plug: Stainless M6x15mm stainless steel screw
(A2 screws in strength class 70)
A Ø10mm drill hole in the glass is required for mounting. The bolt of the glass holder is removable, but this can cause the glass pane to slip in strong winds or other unfavorable weather conditions.
